sketchup number of segments too large for given angle and radius

The SketchUp Book Version 5 (Here’s another way to do the same thing: Click the TIP: There is a quicker way to find this point, by using inference lower edge and pull up in the blue direction. sloped face).* * * Printed from PDF version.

If drawn correctly, the inner the axis (red or green direction) from the upper edge, form should be thin-lined (closed and aligned to the and directly above (blue direction) the lower edge. Then move out so that the construction line is along points shown below. Activate Arc and close the form using the three 21. Hover on the upper edge to pick up its inference.17. Use the intersections of the construction lines to create the three lines shown below. Click the lower edge of the sloped face (not at an endpoint, and without picking up any other inference), so that you can create a construction line parallel to it.16. The next construction line will use a double the other direction. Create another construction line at the same offset in 19.

the new construction line closer to the center.15. Type 2’ and press Enter, to move Construction Geometry / Erase (or Hide). Erase all construction lines by selecting Edit / change the offset. This value is a bit too large, but it’s not too late to 18.

Sketchup number of segments too large for given angle and radius